Email Subscription Enter your email address to subscribe to this blog and receive notifications of new posts by email. Anyone else seen an improvement. As always use this information at your own risk and make sure you have a backup. Thanks to this page, the program and the comments from other folks I was able to change my Windows 7 Prof. At the time of writing the latest version was
|Date Added:||12 September 2005|
|File Size:||58.21 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Anyone else seen an improvement. But this post is not to discuss the pros and cons of IRRT. I then rebooted, set the BIOS to ATA mode, created a system restore point in case the next step rendered Windows unbootableran regedit and used it to import abc. Top Blog at WordPress. Sign up or log in Sign up using Google. One is on the laptop and the other on the E-Port Plus II port expander, which I found works really well, despite not finding any doco at Dell about which port expander suits the E But if it was set up like this, I could not boot Windows.
Hundreds of thousands of people evidently have the same trouble and there are lots of pages with instructions on how to fix it, by one or more registry changes, and then either rebooting with ATA to allow the installation of a driver, or directly changing to AHCI mode. The switch itself e65000 very easy, just go to your bios and change the setting.
The PNP id is the bottom value:. So the final version of this line that made my computer boot properly looked like this: Could you please compile a bit version? Sign up using Facebook. Dell recommends doing this, but they have a very complicated looking alternative here:.
Right Click, select properties and on the Details tab select Hardware Ids. This page seemed to be a lot more clueful, so I spent a few hours following it. Thanks for crafting SCI, Remko. Ifrt to run SCI. It will automatically search for and display all SATA storage controllers:.
Switch SATA Operation Mode | Remko Weijnen’s Blog (Remko’s Blog)
Do you have any idea? You are commenting using your Facebook account. I edited this in two ways, as suggested by Aaron:. I figure this is due to the driver expecting the hardware to be already set up e65500 AHCI operation. Does anyone have idea or solution?
E6500 – Irrt
Hey Remko, was curious if you had time to take a look at the tool? Also make sure you have your BitLocker recovery key available. Fill in your details below or click an icon to log in: I had the same 2 problems like Aaron Wilk.
I e650 tried it already. So how do we obtain the correct values? This enabled me to save a file with a set of commands for changing the registry.
I would like to keep it in my toolbox once you get it updated. Kevin Idrt 5, 11 36 Next follow the steps in MicroSoft KB to verify the msahci service is set to start correctly.